1994 Johnson Evinrude "ER" 90 LV 120 thru 140, 185 thru 225, 250, 300 Service Manual P/N 500612, Page 424Get this manual

1994 Johnson Evinrude "ER" 90 LV 120 thru 140, 185 thru 225, 250, 300 Service Manual P/N 500612, Page 424

7(continued) If no voltage at V3, disconnect bluewhite tilt limit switch bullet connectors and re-connect to by-pass tilt
socketIf red wire is OK, check black wire between relay socket and engine ground If voltage at V5, go to Step 14 rv (greenwhite)voltmeter
black 14Connect lead to clean engine ground, and voltmeter red lead to V7 [!] 15Push control box DOWN trim button If no voltage
at V7, check control box trim switch and wiring If voltage at V7, go to Step 16 [!] 16Push lower motor cover DOWN trim button
If no voltage at V7, check for voltage at greenwhite bullet connector out of lower motor cover trim switchCheck for voltage
at redwhite connector that supplies lower motor cover switch If voltage at V7, go to Step 1717Reinstall DOWN relayPush blades
only halfway into DOWN (green) relay socket 18Push DOWN trim button and check for voltage at If no voltage at va, go to Relay
Ohmmeter Test If voltage at va, go to Step 19 va on relay blade (M terminal of relay) 19Disconnect trim motor's blue and