1994 Johnson Evinrude "ER" 90 LV 120 thru 140, 185 thru 225, 250, 300 Service Manual P/N 500612, Page 426Get this manual

1994 Johnson Evinrude "ER" 90 LV 120 thru 140, 185 thru 225, 250, 300 Service Manual P/N 500612, Page 426

7(continued) 200225 ModelsIf no voltage at V3disconnect bluewhite tilt limit switch bullet connectors and re-connect to by-pass
bracketIf red wire is OK, check black wire between relay bracket and engine ground If voltage at V5, go to Step 14 rv (greenwhite)voltmeter
14Connect black lead to clean engine ground, and voltmeter red lead to V7 [!] 15Push control box DOWN trim button If no voltage
at V7check control box trim switch and wiring, and go to Step 16 If voltage at V7go to Step 16 [!] 16Push lower motor cover
DOWN trim button If no voltage at V7, check for voltage at greenwhite bullet connector out of lower motor cover trim switchCheck
for voltage at redwhite connector that supplies lower motor cover switch If voltage at V7, go to Step 1717Reinstall DOWN
relayPush blades only halfway into bracket in DOWN (green) end of bracket 18Push DOWN trim button and check for voltage at
If no voltage at va, go to Relay Ohmmeter Test If voltage at va, go to Step 19 relay blade (M terminal of relay) 19Disconnect