1994 Johnson Evinrude "ER" 90 LV 120 thru 140, 185 thru 225, 250, 300 Service Manual P/N 500612, Page 429Get this manual

1994 Johnson Evinrude "ER" 90 LV 120 thru 140, 185 thru 225, 250, 300 Service Manual P/N 500612, Page 429

Trim Gauge Troubleshooting 1Turn key switch ON and use voltmeter to check for voltage between trim gauge terminals "I" and
no voltage, check condition of key switch and motor harness 20-amp fuse 4Turn key switch OFFTo avoid immediate meter damage,
never apply an ohm meter to an electrical circuit where voltage is presentRemove trim harness leads from gauge terminals
"S" and "G"Calibrate an ohmmeter on appropriate scale and connect between the leadsWith the engine fully DOWN, meter must
show approximately 88 ohmsWith the engine fully UP, meter must show approximately ohm If your results agree, replace the