1994 Johnson Evinrude "ER" 90 LV 120 thru 140, 185 thru 225, 250, 300 Service Manual P/N 500612, Page 463Get this manual

1994 Johnson Evinrude "ER" 90 LV 120 thru 140, 185 thru 225, 250, 300 Service Manual P/N 500612, Page 463

r:;:;l 8Using either OMC Tilt Cylinder End Cap Remover, PIN 326485, or OMC Universal Spanner Wrench, PIN 912084, and breaker
O-ring and the four valve assemblies which consist of springplungerand check ball Three of the four springs are one length,
and the fourth spring is another lengthUpon reassembly, these springs can be put in any positionInspect the outer O-ring
from the piston and the O-ring that was around the rodReplace the O-rings if necessaryReassemble the piston by placing one
ball, one plunger, and one spring in each of the four holes in the pistonPlace the outside O-ring on the pistoncUsing sharp
screwdriver, pry the scraper out of the end capDiscard the scraperdPry the O-ring out of the end cap using flat toolOnce