1994 Johnson Evinrude "ER" 90 LV 120 thru 140, 185 thru 225, 250, 300 Service Manual P/N 500612, Page 472Get this manual

1994 Johnson Evinrude "ER" 90 LV 120 thru 140, 185 thru 225, 250, 300 Service Manual P/N 500612, Page 472

2Oil both trim caps and install on the trim rods, as shownf3l 3Reinstall the manifold in the holding fixtureOil both trim
of air when you are finishedf61 6Oil both trim end caps and install in the manifoldThread them in flush with the manifold
by handUsing OMC Trim Cylinder End Cap Remover, PIN 324958, and torque wrench, tighten the end caps to torque of 55-60 ftIbs(75-81
Nm) 171 7Install the two identical short check valves in the front of the manifoldTighten the valves to torque of 50-60 in
Ibs(5,5-7,0 Nm) using drag link socket and torque wrench 1sl 8Install the longer trimtilt separation valve in the port lower
side of the manifoldTighten the valve to torque of 50-60 inIbs(5,5-7,0 Nm) 19l 9Oil the pump control piston and install in
the position shownInstall spring on each end of the piston and make sure both springs stay in position correctly when inserting