1994 Johnson Evinrude "ER" 90 LV 120 thru 140, 185 thru 225, 250, 300 Service Manual P/N 500612, Page 475Get this manual

1994 Johnson Evinrude "ER" 90 LV 120 thru 140, 185 thru 225, 250, 300 Service Manual P/N 500612, Page 475

1251 261 27Thread the end cap into the cylinderUsing torque wrench installed 90 to the special tool, tighten the end cap
the manifold as shownInstall the tilt cylinder pin or thrust rod1281 29Rotate the unit into its normal operating positionUsing
the correct fluid, fill the oil reservoir up to the fill plug Install and tighten the fill plugDo not torque the fill plug
at this time16839 30Run the motor, then recheck the oil levelCycle the unit several ti mes and check the oil level when the
trim and tilt cylinders are fully extendedA minimum of five complete cycles (adding oil as needed) is required to purge any