1994 Johnson Evinrude "ER" 90 LV 120 thru 140, 185 thru 225, 250, 300 Service Manual P/N 500612, Page 476Get this manual

1994 Johnson Evinrude "ER" 90 LV 120 thru 140, 185 thru 225, 250, 300 Service Manual P/N 500612, Page 476

Installation 12911Lubricate the tilt cylinder with OMC Triple-Guard grease2Install the electrical cable through the stern
of 18-20 ftIbs(24-27 Nm) 5V4Install the angle adjusting rod in same location as removed i the two thrust rods to torque of
30-35 ftIbs 6V6, V8Install the thrust rodsTighten the nuts on 7Tighten the tilt tube nuts to torque of 50-54 ftIbs(68-73
Nm), then back off one nut 14 turn Motor Servicing If performance problem is indicated in Motor Test, No Load or Troubleshooting-Ammeter