1994 Johnson/Evinrude "ER" CV 85 thru 115 outboards Service Manual, Page 27Get this manual

1994 Johnson/Evinrude "ER" CV 85 thru 115 outboards Service Manual, Page 27

Break-In Procedure During the first 10 hours of break-in operation you must use 50:1 fueloil ratio in your fuel tank in Oil
steady stream of water at the water pump indicatorNext 50 Minutes _._ DO NOT operate engine above half throttle (no more
than 3500 RPM) DO NOT hold constant throttle settingChange engine speed every 15 minutes With easy planing boats, use full
throttle to quickly accelerate boat onto planeImmediately reduce throttle to one-half as soon as boat is on planeBE SURE
boat remains on plane at this throttle settingSecond Hour _._ ._ _._ _._ _._ Use full throttle to accelerate boat onto plane,
then reduce throttle setting to three-quartersBE SURE boat remains on plane at this throttle setting At intervals, apply
full throttle for periods of one to two minutes, returning to three-quarters throttle for cooling period Change engine speed
every 15 minutes INotel Verify water pump operation by looking for steady stream of water at the water pump indicator._ ._
._ _._ _._ _ Avoid continuous full-throttle operation for extended periods Change engine speed every 15 minutes DO NOT exceed