1994 Johnson/Evinrude "ER" CV 85 thru 115 outboards Service Manual, Page 35Get this manual

1994 Johnson/Evinrude "ER" CV 85 thru 115 outboards Service Manual, Page 35

Submerged Engines Engine Dropped Overboard (Not Running) If engine is recovered from water immediately, it must be serviced
(spark plug openings down) and work out all of the water by slowly rotating flywheel approximately 20 times or until there
are no signs of water5Drain carburetorsplace engine in upright position and remove carburetors for disassembly and draining6Starters,
electrical connectors, and all electrical equipment should be completely disassembled, cleaned, flushed with fresh water,
treated with water displacing electrical spray, and thoroughly dried before assembly7Inject outboard lubricant into spark
plug holes8Reassemble parts you removed and disconnected Start engine (follow starting instructions) and run 12 hour using
the "break-in" fueloil mixtureRun the engine on "break-in" fueloil mixture for approximately three hours after servicingSee
Break-in Procedure in this section For models with VRolif oil line has become disconnected, the oil line must be purged and
the system primed before any attempt is made to start the engineRefer to Section 2, OMCVROl 9If engine fails to start, remove