1994 Johnson/Evinrude "ER" CV 85 thru 115 outboards Service Manual, Page 44Get this manual

1994 Johnson/Evinrude "ER" CV 85 thru 115 outboards Service Manual, Page 44

Remote Control Cable InstallationEngine i cables are disconnected at battery "'" To prevent accidental starting of engine,
both anchor block pockets f2l 2Extend throttle cable and lubricate with OMC Triple-Guard grease3Verify that the fast idle
lever is down in the RUN position4While rotating the propeller shaft, move the remote control handle from NEUTRAL to the
FORWARD detent and then halfway back to NEUTRALThis positions the control for proper throttle cable adjustment Failure to
follow this procedure might cause accelerated wear of shift system components and high shifting effort 5Move engine throttle
lever tightly against idle stop screw i locknut and washer supplied with engineTighten lock- 6Attach cable casing guide to
throttle lever pin using nut securely f4l 7Pull firmly on throttle cable to remove backlash and install trunnion nut in anchor
pocket8Temporarily install cable retainer and screw9Check cable adjustment; if throttle cable adjustment is too loose, idle