1994 Johnson/Evinrude "ER" CV 85 thru 115 outboards Service Manual, Page 45Get this manual

1994 Johnson/Evinrude "ER" CV 85 thru 115 outboards Service Manual, Page 45

Shift Cable '-=I grease 1Extend shift cable and lubricate with OMC Triple-Guard 2Verify that the fast idle lever is down
the adjustment in Step 7, or ifthe gearcase detent does not correspond with remote control NEUTRAL in Step 10, refer to Section
for shift rod height adjustment i and washer supplied with engineTighten locknut 11Attach shift cable to shift lever pin
using locknut securelyWhen installing OMC Accessory Controls, except for surface mount, the shift cable must be adjusted
and installed when the control and engine are in NEUTRAL12Slip rubber grommet onto control cables and press grommet into
groove in lower engine cover i attached to the proper engine levers by lifting the fast idle lever to the START positionIf
correctly attached, the throttle cable and engine throttle lever will moveWhen installing remote control that is not manufactured
by Outboard Marine Corporation, you must verify that the shift cable stroke is compatible with this engineThis engine is