1994 Johnson/Evinrude "ER" CV 85 thru 115 outboards Service Manual, Page 61Get this manual

1994 Johnson/Evinrude "ER" CV 85 thru 115 outboards Service Manual, Page 61

Installation Recommendations Carefully, follow the installation instructions packaged with the VRO oil reservoirIncorrect
the installation is extended, the oil hose between the primer bulb and engine must be one continuous section with no fittings
or connectionsDo not add on to the existing hoseThe wiring harness can be extended by soldering on additional 16-gauge wire
to each leadProtect the connections with shrink tube and electrical tapeObserve proper wire color for identification4When
making connections in the oil supply system, use only the clamp supplied with the system Do not use tie strapsThey do not
provide adequate clamping action Do not use metal worm clamp on vinyl hoseIt can damage the hose and cause leakage5Test the
"low oil" warning circuit before filling the oil reservoir: Make all electrical connections and connect the engine's battery
Turn the key switch ON With the reservoir empty, the warning horn should sound for 12 second every 40 seconds With the reservoir