1994 Johnson/Evinrude "ER" CV 85 thru 115 outboards Service Manual, Page 64Get this manual

1994 Johnson/Evinrude "ER" CV 85 thru 115 outboards Service Manual, Page 64

Component Servicing Anytime the VRO oil supply line has been disconnected from the engine, you must run 50 :1 fuell oil mixture
to remove any contamination Install the filter, being careful not to move the pickup assembly on its support rods2With the
pickup assembly out ofthe reservoir, vacuum test the system to check for air leaksCarefully, remove the oil hose from pickup
assembly and from engine oil inlet fitting Use low pressure air to purge hose of oil Use cap holder, PI 329661to plug pickup
end of hose Attach vacuum tester to the engine end of oil line and draw inHg vacuum The oil system is good if it can maintain