1994 Johnson/Evinrude "ER" CV 85 thru 115 outboards Service Manual, Page 108Get this manual

1994 Johnson/Evinrude "ER" CV 85 thru 115 outboards Service Manual, Page 108

Power Pack Removal 1Separate the power pack connector(s)Twist and remove the primary lead covers from the ignition coils
install the power pack ground lead where indicated and install the retaining screwsTighten the screws to torque of 60-84
inIbs(7-9 Nm)4Apply isopropyl alcohol to the Amphenol connectorsAlign flat areas and carefully plug togetherSecure with wire
retainer where used5Lightly coat the openings of the primary lead covers and install them on ignition coil terminalsObserve
proper wire routing and ignition timingrefer to Ignition Coil InstallationAfter replacing any major ignition component, verify