1994 Johnson/Evinrude "ER" CV 85 thru 115 outboards Service Manual, Page 114Get this manual

1994 Johnson/Evinrude "ER" CV 85 thru 115 outboards Service Manual, Page 114

OUTPUT TESTS ill plugs installed and torqued in the cylinder headIf neces- I:A All cranking output tests must be performed
mm) from any metal surface L.ll or spark tester during cranking tests "" To avoid possible shock hazard, do not handle ignition
coils 3If equipped, install the emergency stop switch clip and lanyard assemblyCrank the engineSpark should jump each tester
gap alternately If tester shows good output on all cylinders, go to STEPRUNNING OUTPUT TEST If tester shows good output on
at least one cylinder, go to STEPSENSOR COIL TEST If tester shows no output, go to STEPSTOP CIRCUIT TEST4Refer to Troubleshooting
Sequence ChartStart with your specific fault symptom and continue troubleshooting in sequenceIt is possible for the ignition
system to have problem but still produce good outputIf the engine "pops" or "backfi res" during starting, the ignition may