1994 Johnson/Evinrude "ER" CV 85 thru 115 outboards Service Manual, Page 123Get this manual

1994 Johnson/Evinrude "ER" CV 85 thru 115 outboards Service Manual, Page 123

STEPRUNNING OUTPUT TEST 1Twist and remove all primary leads from ignition coilsG512.atwist to install Stevens Instrument
voltmeter to "POS" and "500"G515C.onnect voltmeter red lead to No.1 terminal extenderConnect meter black lead to clean engine
ground 6Start engine and run under load at RPM where ignition problem exists Meter must show 230 volts or higher7Repeat Steps
and for remaining cylinders If one or more cylinders show low output, go to STEPCHARGE COIL TEST If one or more cylinders
show no output, go to STEPSENSOR COIL TEST8Remove terminal extenders and install ignition coil primary leadsObserve proper