1994 Johnson/Evinrude "ER" CV 85 thru 115 outboards Service Manual, Page 143Get this manual

1994 Johnson/Evinrude "ER" CV 85 thru 115 outboards Service Manual, Page 143

135 125The wrist pin fit is loose on both sidesPush the wrist pin through to free the piston from the connecting rodIf necessary,
ball hone or other suitable tool'" To avoid personal injury, wear eye protection and rubber i gloves when using OMC Gel-Seal
and Gasket Remover r:;;] 4Use OMC Gel-Seal and Gasket Remover to remove all traces of gasket, adhesives, and OMC Gel-Seal
I from the cylinder block and crankcase5Carefully remove any carbon accumulation from the tops and ring grooves of the pistonA
ring groove cleaning tool can be made by breaking an old ring and grinding an angle on its endDo not damage ring grooves
while cleaning6Thoroughly wash entire cylinder block and crankcase with warm, soapy water to remove all traces of contaminants
1381 7Air dry cylinder block and crankcaseBlowout all holes and passageways with compressed airClean the center main bearing
recirculation passage with OMC Cleaning SolventClean passage only in direction of fluid flow ill compressed air pressure