1994 Johnson/Evinrude "ER" CV 85 thru 115 outboards Service Manual, Page 144Get this manual

1994 Johnson/Evinrude "ER" CV 85 thru 115 outboards Service Manual, Page 144

Inspection 1Before any inspection process can begin, all internal components must be clean and free of excess oil 2Make visual
Install seal rings in their original positions on crankshaft after inspection 14216Use aeach cylindergauge for inside-reading
micrometer or telescoping or to inspect bore an out-of-round, oversize, tapered conditionBe sure the gauge or micrometer
is perfectly square in the bore when measuring 14317Measure eachmeasuredin at least two areas as betweenEach cylinder showntwiceThe
difference the area should be two measurements in each area is the cylinder out-of-round dimension The cylinder must not
be out of round by more than 0.004 in(0,10 mm) 1431S' !he dimensional cylinder taper difference between the two areas is
The cylinder taper must not exceed 0.002 in(0,05 mm) r::;l9The difference between your measurements and standard bore dimension
is cylinder oversizeRefer to Engine Specifications, Section 1, for dimensions The cylinder must not be oversize by more than