1994 Johnson/Evinrude "ER" CV 85 thru 115 outboards Service Manual, Page 146Get this manual

1994 Johnson/Evinrude "ER" CV 85 thru 115 outboards Service Manual, Page 146

(1 1115 modelsIf filler blocks were removed, they must be L!J installed flush with the cylinder blockNew filler blocks must
new lower main bearing: Oil the end of the crankshaftUse OMC Crankshaft BearinglSleeve Installer, PIN 338648, and place bearing
onto crankshaft with lettered side facing the toolInstall bearing until it seats in the crankshaft1sl 6To install new crankshaft
sleeve: Oil the end of the crankshaftPlace the sleeve in OMC Crankshaft Bearingl Sleeve, PIN 338648, and drive the sleeve
onto the crankshaft until the installer contacts the lower main bearing If the installer sticks on the sleeve after installation,
thread OMC Slide Hammer, PIN 391008, into installer and pull offInspect sleeve surface after installingSleeve must not be
used if surface is damagedf61 7Lubricate new driveshaft a-ring and lightly lubricate crankshaft splines with OMC Moly LubeInstall