1994 Johnson/Evinrude "ER" CV 85 thru 115 outboards Service Manual, Page 150Get this manual
31Rotate cylinder block so that crankcase mating flange is facing up 123132Remove all spark plugs and push all pistons to
pull the connecting rods up to crankshaft and install bearings 126135Lubricate threaded portion of the rod cap screws with
Evinrude or Johnson Outboard Lubricant and install both rod caps finger tight tel Be sure that both dots face flywheelmatches
dot on alignment dot on rod cap rod and Torquing the screws without OMC Alignment Fixture, PIN 396749, or using an incorrect
procedure, could cause permanent damage to the connecting rod and crankshaftTo maintain accurate torque values, keep extension
length to minimum 128136Torque the rod cap screws using OMC Rod Cap Aligning Fixture, PIN 396749Align the flat marked "set"