1994 Johnson/Evinrude "ER" CV 85 thru 115 outboards Service Manual, Page 152Get this manual

1994 Johnson/Evinrude "ER" CV 85 thru 115 outboards Service Manual, Page 152

45Thoroughly clean and degrease the crankcase mating flange of the cylinder block with OMC Cleaning Solvent and let air dry46Apply
with the center screws and work outward in spiral pattern136152Temporarily install the flywheel and key to rotate crankshaft
and check for bindingIf binding occurs, tap bottom of crankshaft with rawhide mallet and recheck53Install the crankcase flange
screws and torque to 60-84 inIbs(7-9 Nm)1371138154Apply OMC Locquic Primer and OMC Nut Lockto the upper and lower crankcase
head screws and install themTighten the screws to torque of 96-120 inIbs(11-14 Nm)139155Apply OMC Gasket Sealing Compound
to outside diameter of the temperature sendersSeat the senders in the cylinder heads56Apply OMC Gasket Sealing Compound to
two new cylinder head cover gasketsInstall the cylinder head coversStarting with the center screws, tighten to torque of
60-84 inIbs(7-9 Nm) r;;J 57Apply OMC Gasket Sealing Compound to two new exhaust cover gasketsPlace the inner and outer exhaust