1994 Johnson/Evinrude "ER" CV 85 thru 115 outboards Service Manual, Page 154Get this manual

1994 Johnson/Evinrude "ER" CV 85 thru 115 outboards Service Manual, Page 154

Installation 1Remove the nuts from the powerhead adapter studs rv splines withnew O-ring on the driveshaftCoat top surface
the lifting eyeUsing an adequate hoist, lift the powerheadf31 4Install new powerhead to adapter gasket dryUse no sealer5Place
the powerhead onto the adapterRotate the powerhead slightly back and forth to align the crankshaft and the driveshaft splinesf41
6Coat the threads of the exhaust housing to powerhead screws with OMC Gel-Seal II and install themTorque the screws in stages
to the following values: Exhaust Housing to Powerhead Screws 3Use OMCUniversal Puller and Lifting Eye, PIN 321537, 16-18
ftIbs(22-24 Nm) PCE0063 f511sl 7Coat the threads ofthe adapter to powerhead screws and nuts with OMC Gel-Seal II, and install