1994 Johnson/Evinrude "ER" CV 85 thru 115 outboards Service Manual, Page 170Get this manual

1994 Johnson/Evinrude "ER" CV 85 thru 115 outboards Service Manual, Page 170

- Disassembly '8l 1To separate the adapter and the inner exhaust housing assembly from the outer exhaust housing, remove
Place the upper thrust mount into the adapterPosition radius side of the mount facing aft and "TOP" mark facing ] 2Place
the mount plate onto the thrust mountr:j3l3Apply OMC Nut Lock to threads of the small thrust mount screwHand tighten the
screw in rear hole Check the condition of the seal on the inner exhaust housing and replace if necessaryApply OMC Adhesive
Mto seal surface of the housing before installing new seal 5Apply OMC Adhesive to the outside diameter of new grommet and
position the water tube and water tube grommet in the base of the inner exhaust housing6Place new inner exhaust housing gasket