1994 Johnson/Evinrude "ER" CV 85 thru 115 outboards Service Manual, Page 187Get this manual

1994 Johnson/Evinrude "ER" CV 85 thru 115 outboards Service Manual, Page 187

20 7Put tie straps on braided tube ends and attach stop switch assembly to outer handlef21l 8Install the idle adjustment
the stop button leads and throttle cable through the lower engine cover grommet2Apply OMC Triple-Guard grease to the two
steering handle bushingsPlace the bushings into the steering bracketAttach the steering handle to the bracket 20 ill lockingReplace
the nut it if has lost is locking feature '" The steering handle nut must have nylon patch for Tighten the nut so the steering
handle can be pivoted and maintain any position3Secure the stop button lead to the powerhead 4Using OMC Pin Insert Tool,
PI 322697, and isopropyl alcohol, insert the wire into 1-pin Amphenol connector 5Thread the throttle cable bracket, jam nut,
and pivot connector on the throttle cable 6Refer to Synchronization and Linkage Adjustments, Section 1, to adjust the throttle