1994 Johnson/Evinrude "ER" CV 85 thru 115 outboards Service Manual, Page 193Get this manual

1994 Johnson/Evinrude "ER" CV 85 thru 115 outboards Service Manual, Page 193

Propeller InstallationV6 These instructions apply when spacer is brassIf spacer is made of nylon, replace with brass spacer,
on propeller shaft by aligning splines and pushing until it seats on the thrust bushing [!] 6Install the spacerengaging the
propeller shaft splines7Wedge block of wood between propeller blade and the anti-ventilation platef1l f1l 8Install the propeller
nut 70-80 ftIbs(95-105 Nm) and tighten to torque of Position keeper on propeller nut with one space between tabs aligned
with cotter pin hole in propeller shaftIf keeper will not align with cotter pin hole, tighten propeller nut to achieve alignmentDo