1994 Johnson/Evinrude "ER" CV 85 thru 115 outboards Service Manual, Page 195Get this manual

1994 Johnson/Evinrude "ER" CV 85 thru 115 outboards Service Manual, Page 195

3Place the a-ring Q) in groove in the impeller housing4Lightly coat the exterior of the impeller cup with OMC Gasket Sealing
the gasket and impeller '31 2Apply OMC Triple-Guard grease to new impeller a-ring Slide the a-ring down the driveshaft until
it contacts the impeller plate3Apply OMC Needle Bearing Assembly Grease to flat area of the driveshaftInstall the drive cam
The sharp edge of the cam is the leading edge during driveshaft rotation 4Slide the water pump assembly down the driveshaftAlign
impeller slot with the impeller camRotate the driveshaft to engage the impeller cam with the impeller, and slide water pump
assembly down over impellerBe sure impeller cam does not fall out of positionVerify that the impeller engages the impeller
cam properlySerious powerhead damage will result if impeller cam is displaced 5Align the impeller housing with the gearcaseApply