1994 Johnson/Evinrude "ER" CV 85 thru 115 outboards Service Manual, Page 201Get this manual

1994 Johnson/Evinrude "ER" CV 85 thru 115 outboards Service Manual, Page 201

i OMC Retaining Ring Pliers, PIN 331045Retaining rings 5V4If equipped, remove the two retaining rings using are under extreme
Socket PIN 311875 Q) and OMC Pinion Holder PIN 334455 Pad the handle of the holder to prevent damage to the gearcasePull
up on the driveshaft to remove it from the gearcaseThe driveshaft to pinion taper is locking taperIf necessary, use OMC Puller
PIN 390706 and OMC Backing Plate PIN 325867 W to break the lockInstall the tools as shown by clamping them around the driveshaft
with the tool's set screw aligned with the water pump drive cam slotThen, tighten the set screw into the slotAlternately
tighten the two vertical screws against the backing plate inserted between the puller and the gearcase until the driveshaft
pops loose from the pinion, then remove the toolsr:J3l 12The bearing housingshimsthrust bearing thrust washer will come out
with the driveshaft I11l f121 11 COA3558 Reach inside the gearcase and remove the pinion and pinion nut V6Remove any loose