1994 Johnson/Evinrude "ER" CV 85 thru 115 outboards Service Manual, Page 204Get this manual

1994 Johnson/Evinrude "ER" CV 85 thru 115 outboards Service Manual, Page 204

1281 25V4Remove the water intake screen by depressing the tabs and pushing upwardInspect the screen for blockage PropelJer
thoroughlyIf bearings were not replaced, rotate the needles with your fingers to check for freedom of movementInspect O-ring
groove, and sand off any sharp edges that would cut the O-ring and prevent its sealing V4Thoroughly clean the threads of
the four bearing housing retaining screwsDiscard the retaining screws' seals rJl 4Inspect the bearing housing anodeReplace
anode if it has eroded to two-thirds its original size5Oil, then install new bearings in the bearing housing V4use OMCBearing
Installer PIN 326562 to install the forward bearing and rear bearing V6use OMCBearing Installer PIN 339750 to install the
forward bearing and rear bearing Place the lettered end of the bearing case on the bearing installer, then press the bearing