1994 Johnson/Evinrude "ER" CV 85 thru 115 outboards Service Manual, Page 205Get this manual

1994 Johnson/Evinrude "ER" CV 85 thru 115 outboards Service Manual, Page 205

6 DR2061-DR2062 6Install two new seals back to back in the rear of the bearing housing V4use OMC Seal Installer, PIN 326551
inspect the driveshaft bearing surface if the bearing is damaged14156 Remove the two driveshaft bearing housing seals using
OMC Puller Bridge PIN 432127 and OMC Large Puller Jaws PIN 432129Discard the seals 2Remove the a-ring from the bearing housing
and discard3Clean the bearing housing in solvent to remove sealer from the seal bore and the a-ring groove1sl4Install new
seals back to back in the bearing housing using OMC Seal Installer PIN 330268Apply OMC Gasket Sealing Compound to the metal
casings of the seals before installingInstall the inner seal with flush lip facing toward the bearing housing, then the outer
seal with extended lip facing away from the bearing housingApply OMC Triple-Guard grease to the seal lips after installing