1994 Johnson/Evinrude "ER" CV 85 thru 115 outboards Service Manual, Page 209Get this manual

1994 Johnson/Evinrude "ER" CV 85 thru 115 outboards Service Manual, Page 209

f41 7Lightly coat the detent ball and spring with OMC Needle Bearing Assembly GreaseFirst, insert the spring in the housing,
shifter toward the housing, then reach inside and attach it to the detent leverAlign the pivot holes and insert the retaining
pin f81 11Push the detent lever down to its most depressed positionRest the cradle on the shift shaft CD, then attach the
cradle and shaft to the wide arms of the shifterPull the detent lever back up to NEUTRAL position to hold the cradle and
shaft in place19l 12Coat thrust bearing and thrust washer with OMC Needle Bearing Assembly GreasePlace the bearing on the
back of the forward gearSet the washer on top of the thrust bearing Insert the gear, bearing, and washer assembly into the