1994 Johnson/Evinrude "ER" CV 85 thru 115 outboards Service Manual, Page 210Get this manual

1994 Johnson/Evinrude "ER" CV 85 thru 115 outboards Service Manual, Page 210

1-' -=CO=B7=S8:-::-'1 The clutch dog is not symmetricalIf installed backward, it will not fully engage forward gear and
into the gearcase, being sure to align the shift housing pin with hole in forward end of gearcase housingTriple-Guard greaseInstall
the O-rings into the shift rod coverPlace the shift rod grommet and shift rod spacer (TX models) on the shift rodGrease the
threaded end of the shift rod and insert it through the coverTurn the shift rod while pushing it through the cover to avoid
damaging the O-ringsf161 18Apply OMC Gasket Sealing Compound to both sides of new shift rod cover gasket Position the gasket
on the gearcaseThread the shift rod into the detent lever about four turns19Move shift rod from side-to-side while pushing
on the propeller shaft to ensure proper alignment of the bearing housing locator pin into the locator pin hole in the gearcaseTap
the end of the propeller shaft with plastic or rawhide mallet to fully seat the bearing housingf17l 20Apply OMC Gasket Sealing