1994 Johnson/Evinrude "ER" CV 85 thru 115 outboards Service Manual, Page 211Get this manual

1994 Johnson/Evinrude "ER" CV 85 thru 115 outboards Service Manual, Page 211

G8l 21Position the driveshaft thrust bearingthrust washer , and shim(s) (selected earlier) on the driveshaft bearingwasher
install the driveshaft25Lightly coat the threads of the pinion nut with outboard lubricant and install on the driveshaftTurn
the driveshaft by hand to engage the nut 26Turn the gearcase right side upUsing OMC Driveshaft Socket PIN 311875 and OMC
Pinion Nut Holder PI 334455, torque the pinion nut to 70-80 ftIbs(90-108 Nm)Overtorquing or undertorquing the pinion nut
will reduce pinion lifeDo not reuse damaged pinion nuts 1221 27Position the washers on the driveshaft bearing housing screwsApply
OMC Gasket Sealing Compound to the threads ofthe screwsInstall and tighten screws to torque of 168-192 inIbs(19-22 Nm) 1231
28Oil, then install the thrust bearing Q) and large thrust washer CD on the hub of the reverse gearSlide the reverse gear