1994 Johnson/Evinrude "ER" CV 85 thru 115 outboards Service Manual, Page 214Get this manual

1994 Johnson/Evinrude "ER" CV 85 thru 115 outboards Service Manual, Page 214

Installation Coat the driveshaft splines with OMC Moly LubeDo not coat top surface of the driveshaft as lubricant here may
to threads of the gearcase retaining screwsInstall the screws and tighten to the following torques: inscrews inscrews 264-288
inIbs(30-33 Nm) 30-32 ftIbs(41-43 Nm) inscrews inscrews 26-28 ftIbs(35-38 Nm) 45-50 ftIbs(61-68 Nm) 5Apply OMC Gasket Sealing
Compound to threads of the trim tab screwInstall the trim tab and align it with the index marksTighten the screw to torque
of 120-144 inIbs(14-16 Nm) '" 6E!"gage the shift rod in the shift rod link and secure retainer '7l7Position the shift rod
seal on the shift rod just below the lower engine coverIt is important that this seal be in place as it prevents water from