1994 Johnson/Evinrude "ER" CV 85 thru 115 outboards Service Manual, Page 221Get this manual

1994 Johnson/Evinrude "ER" CV 85 thru 115 outboards Service Manual, Page 221

19Remove retainer ring if requiredDiscard retainer ring f15120To assemble bearings to driveshaft, install new retaining ring
outMake sure the retaining ring is seated in its groove in the driveshaftWear safety glasses and proceed with care to avoid
unsnapping the ring from the pliers 118l23Install thrust washer against upper bearing with dished center section facing upwardPlace
upper seal carrier assembly onto the driveshaftApply OMC Triple-Guard grease to two new O-rings and install on upper seal
carrierr:J9l24bearing housing cavity with OMC Marine Wheel Bearing Grease 120125Heat the bearing housing slightly with propane
torch Press the driveshaft and bearing assembly into the bearing housing until seated'" 26Allow the bearing housing to cool