1994 Johnson/Evinrude "ER" CV 85 thru 115 outboards Service Manual, Page 226Get this manual

1994 Johnson/Evinrude "ER" CV 85 thru 115 outboards Service Manual, Page 226

Jet Drive Adjustments Impeller Clearance Adjustment If loss of performance combined with higher than normal wide-open-throttle
and decrease clearance Moving one shim will reduce clearance approximately 0.007" i and remove all spark plug leads "" To
avoid accidental starting of engine while servicing, twist f213Remove six screws retaining the intake housing to the jet
housingRemove the intake housing4Bend tab-lock washer ears and remove impeller nut Remove tab-lock washer and discard 5Remove
shimsimpeller, key, and impeller sleeve from driveshaft6Use flat file and remove any nicks or burrs from edge of impeller7Transfer
one or more shims from bottom to top of impellerLubricate impeller driveshaft hole, impeller sleeve, and key with OMC Triple-Guard
grease prior to assembling parts8Place impeller back onto driveshaft, aligning impeller key and sleeve in impeller Safety