1994 Johnson/Evinrude "ER" CV 85 thru 115 outboards Service Manual, Page 228Get this manual

1994 Johnson/Evinrude "ER" CV 85 thru 115 outboards Service Manual, Page 228

Shift Cable AdjustmentRemote Control Models i from forward boat travel could move the gate into RE- "" The shift cable must
snap into NEUTRAL detent when you pull up on the reverse gate with moderate pressure6If you cannot achieve NEUTRAL detent,
lengthen cable slightly and recheck your adjustmentIt is very important that the reverse gate must remain locked in the FORWARD
detent range when remote control is in FORWARDWhen properly adjusted, the reverse gate cannot be pulled out of the FORWARD
detent range by hand7Tighten locknut and loosen movement of cam18 Important to V4 turn to permit free f1318Loosely secure
shift cable to the steering cable with tie strapDO NOT restrict movement of the shift cableWith engine running in NEUTRAL
and warm-up lever raised, engine will run rough due to exhaust restriction from the reverse gate being in NEUTRAL Safety