1994 Johnson/Evinrude "ER" CV 85 thru 115 outboards Service Manual, Page 229Get this manual

1994 Johnson/Evinrude "ER" CV 85 thru 115 outboards Service Manual, Page 229

Shift Rod AdjustmentTiller Models i from forward boat travel could move the gate into RE- "'" The shift cable must be adjusted
pin with washer f1714Move shift handle to NEUTRALThe cam roller should snap into NEUTRAL detent when you pull up on the reverse
gate with moderate pressure5If you cannot achieve NEUTRAL detent, remove connector pin then rotate connector to lengthen
shift rod slightlyRecheck your adjustmentIt is very important that the reverse gate must remain locked in the FORWARD detent
range when shift handle is in FORWARDWhen properly adjusted, the reverse gate cannot be pulled out of the FORWARD detent