1994 Johnson/Evinrude "ER" CV 85 thru 115 outboards Service Manual, Page 247Get this manual

1994 Johnson/Evinrude "ER" CV 85 thru 115 outboards Service Manual, Page 247

Cleaning and Inspection 1Inspect the brushes; replace if one-half worn, damaged, or crackedReplace brush springs, if weak2Clean
magnets will cause excessive RPM on No Load Current Draw, Electric Starter test5Do not clean the starter drive assembly while
the starter motor and drive are installed on the powerheadThe cleaning agent could drain into the starter motor, washing
dirt from the drive into the starter bearings and commutatorAfter disassembling the drive, clean each part with grease solvent
and inspect for wear or distortion6If the pinion does not properly engage the flywheel, the pinion and screw shaft assembly
may be worn, distorted, or dirtyLocate the cause of binding and correct before completing assembly 714Check permanent magnetsMagnets