1994 Johnson/Evinrude "ER" CV 85 thru 115 outboards Service Manual, Page 280Get this manual

1994 Johnson/Evinrude "ER" CV 85 thru 115 outboards Service Manual, Page 280

7(continued) If no voltage at V3, disconnect bluewhite tilt limit switch bullet connectors and re-connect to by-pass tilt
black wire between relay sockets and engine ground If voltage at V5, go to Step 1414Connect voltmeter black lead to clean
engine ground, and voltmeter red lead to V7 (greenwhite) [!] 15Push control box DOWN trim button If no voltage at V7, check
control box trim switch and wiring, and go to Step 16 If voltage at V7, go to Step 16 [!] 16Push lower motor cover DOWN trim
button If no voltage at V7, check for voltage at greenwhite bullet connector out of lower motor cover trim switchCheck for
voltage at red connector that supplies lower motor cover switch If voltage at V7, go to Step 1717Reinstall DOWN relayPush
blades only halfway into DOWN (green) socket 18Push DOWN trim button and check for voltage at V8 on relay blade (M terminal
of relay) If no voltage at V8, go to Relay Ohmmeter Test If voltage at V8, go to Step 19 19Disconnect trim motor's blue and
green power wire connector (leave relay in socket)20Push DOWN trim buttonCheck for voltage on green wire If no voltage, check