1994 Johnson/Evinrude "ER" CV 85 thru 115 outboards Service Manual, Page 283Get this manual

1994 Johnson/Evinrude "ER" CV 85 thru 115 outboards Service Manual, Page 283

Trim Gauge Troubleshooting 1Turn key switch ON and use voltmeter to check for voltage between trim gauge terminals "I" and
no voltage, check condition of key switch and motor harness 20-amp fuse4Turn key switch OFF fN=J To avoid immediate meter
damage, never apply an ohmmeter to an electrical circuit where voltage is present Remove trim harness leads from gauge terminals
liS" and "G"Calibrate an ohmmeter on appropriate scale and connect between the leadsWith the engine fully DOWN, meter must
show approximately 88 ohmsWith the engine fully UP, meter must show approximately ohm If your results agree, replace the