1994 Johnson/Evinrude "ER" CV 85 thru 115 outboards Service Manual, Page 312Get this manual

1994 Johnson/Evinrude "ER" CV 85 thru 115 outboards Service Manual, Page 312

f21 8Install pressure gauge and adapter "A" to check problems in the UP circuitTighten gauge and adapter lightly to 5-10
12Following Steps through 9, install pressure gauge and adapter "B" to check problems in the DOWN circuit13With all cylinders
completely extended, begin running the unit DOWN The gauge should show approximately 800 PSI (5516 kPa) as the cylinders
are retracting The gauge should show approximately 900 PSI (6206 kPa) as the unit stalls The stall pressure reading must
not drop by more than 200 PSI (1379 kPa) after the motor stops14If your test results vary from those in Step 13, problem
in the DOWN circuit is indicatedRefer to Page 8-45 for list of possible faults10572 IV 15After tests are complete, install
the manual release valve and torque to 45-55 inIbs(5-6 Nm) Install retaining ring "'" Manual release valve must be properly