1994 Johnson/Evinrude "ER" CV 85 thru 115 outboards Service Manual, Page 315Get this manual

1994 Johnson/Evinrude "ER" CV 85 thru 115 outboards Service Manual, Page 315

Power TrimTilt Servicing Removal 1Mark angle adjusting rod location and remove rod2Lift engine manually and engage tilt support3Remove
the power trimtilt unit before disassemblingUsing battery, operate the unit until the trim and tilt cylinders are completely
downReverse the connections on the battery and momentarily operate the unit I.A There may be high pressure behind some check
valves and hydraulic linesTo prevent possible eye injury, when removing lines and check valves, be sure to keep clean, "lint
free" shop cloth covering them until the pressure is releasedUse eye protection ill sive temperature can cause high pressure
leaks or failure of partsAlways use "Iintfree" shop cloth when handling power trim and tilt componentsIf painting the unit
is required, paint the unit after it is completely assembledPainting of individual components may cause flakes of paint to