1994 Johnson/Evinrude "ER" CV 85 thru 115 outboards Service Manual, Page 316Get this manual

1994 Johnson/Evinrude "ER" CV 85 thru 115 outboards Service Manual, Page 316

oCOA2417 1sl1Be sure the manual release valve is screwed in all the wayRemove the retaining ring using OMC Retaining Ring
each endInspect all four a-rings and replace a-rings if necessaryf11l7Position the unit as shownSlide the tilt cylinder retaining
pin out ofthe unitRemove the tilt cylinderVery carefully and slowly, cycle the cylinder once or twice while aiming the oil
feed ports down towa'rd the oil drain panRemove the two nylon bushings from the cylinderf1218Currently, there are two styles
of tilt cylindersIdentify which one you have prior to making any repairs or selecting replacement partsThe cylinder shown
at the top of the figure is referred to as the Showa brand cylinderThe cylinder shown at the bottom of the figure is referred
to as the Prestolite brand cylinderWhen replacing an entire cylinder, either one can be usedWhen replacing individual parts