1994 Johnson/Evinrude "ER" CV 85 thru 115 outboards Service Manual, Page 317Get this manual

1994 Johnson/Evinrude "ER" CV 85 thru 115 outboards Service Manual, Page 317

r:J3l 9When servicing either cylinder, mount the bottom part of cylinder in soft-jaw viseIf equipped, remove the band nut
scoring is present14Service the Showa piston and rod assembly as followsUsing OMC Hydraulic Cylinder Rod Holder, PI 983213,
clamp the rod tightly in viseRemove the nut and washer from the piston end of the rodthe four valve assemblies which consist
of springplungerand check ball Three of the four springs are one length, and the fourth spring is another lengthOn reassembly,
these springs can be put in any positionInspect the outer O-ring from the piston and the O-ring that was around the rodReplace
the O-rings if necessaryReassemble the piston by placing one ball, one plunger, and one spring in each of the four holes