1994 Johnson/Evinrude "ER" CV 85 thru 115 outboards Service Manual, Page 318Get this manual

1994 Johnson/Evinrude "ER" CV 85 thru 115 outboards Service Manual, Page 318

23 COA2433 120 IcUsing sharp screwdriver, pry the scraper out of the end capDiscard the scraperscraper and O-ring have been
threads on the tilt rodUsing OMC Tilt Cylinder Seal Protector, PIN 326005, slide the end cap onto the rod COA2435 of the
nutSpray threads with OMC Locquic Primer and let dryApply small amount of OMC Nut Lock to the threads of the nutSlide the
washer over the threadsInstall the nutTighten the nutto torque of 58-87 ft.lbs{79-118 Nm}.lffor some reason the rod has been
unscrewed from the eyelet, clean the threads of the rod at that end and the threads inside the eyelet with OMC Locquic PrimerApply
small amount of OMC Nut Lock to the threads, thread the rod into the eyelet, and torque both the nut and the rod into the
eyelet at the same time15Service the Presto lite piston and rod as follows: 261 iClean any Locktite material from the threads