1994 Johnson/Evinrude "ER" CV 85 thru 115 outboards Service Manual, Page 319Get this manual

1994 Johnson/Evinrude "ER" CV 85 thru 115 outboards Service Manual, Page 319

bQuickly clamp the piston tightly in soft-jaw viseUsing breaker bar or similar tool through the eyelet, unscrew the rod from
and back-up ring from the end capDiscard the a-ringeOil and install new a-ring and back-up ring in the end capThe square
back-up ring goes above the a-ringfUse heat lamp or hot water to warm new scraperInstall the scraper in the end cap with
the lip facing upgSecure the eyelet end of the rod in soft-jaw viseUsing OMC Tilt Cylinder Seal Protector, PIN 326005, slide
the end cap onto the rod in the direction shownPlace new outside a-ring on the end caphSpray the threads of the rod and the
internal threads of the piston with OMC Locquic PrimerIn soft-jaw vise, secure the piston firmly with the smaller valve holes