1994 Johnson/Evinrude "ER" CV 85 thru 115 outboards Service Manual, Page 325Get this manual

1994 Johnson/Evinrude "ER" CV 85 thru 115 outboards Service Manual, Page 325

1731 52Remove and discard the seals from the trim pistonsCarefully clean the trim pistons and rods and install new seals1741
excess solvent from the internal passages with compressed airIt is essential that the manifold and all components be kept
absolutely clean and dust freeAny dirt in the system could cause scoring of cylinder bores, sticking of valves, or damage
to pump componentsAssembly Use only OMC Power TrimlTilt and Power Steering Fluid or GM Dexronautomatic transmission fluid
to fill the hydraulic system1Oil and install both trim sleevesThe seals of the sleeves must face downWhen installing, press
the sleeves to the bottom of the bore as far as they will goThe top of the sleeves will almost reach the bottom of the threads