1994 Johnson/Evinrude "ER" CV 85 thru 115 outboards Service Manual, Page 326Get this manual

1994 Johnson/Evinrude "ER" CV 85 thru 115 outboards Service Manual, Page 326

02 Oil and install both trim caps on the trim rods, as shown both trim piston and cap assemblies into the manifoldSlide the
in the manifoldThread in flush with the manifold by handUsing OMC Trim Cylinder End Cap Remover, PIN 324958, and torque wrench,
tighten the end caps to torque of 55-60 ftIbs(75-81 Nm)rJl7Install the two identical short check valves in the front of l!J
the manifoldTighten the valves to torque of 50-60 inIbs(5,5-7,0 Nm), using drag link socket and torque wrench!al8Install
the longer trimltilt separation valve in the port lower side of the manifoldTighten the valve to torque of 50-60 inIbs(5,5-7,0
Nm) 1313Reinstall the manifold in the holding fixtureOil and install Oil and install the pump control piston in the position
shownInstall spring on each end of the piston and make sure both springs stay in position correctly when inserting the valve