1994 Johnson/Evinrude "ER" CV 85 thru 115 outboards Service Manual, Page 329Get this manual

1994 Johnson/Evinrude "ER" CV 85 thru 115 outboards Service Manual, Page 329

12511261 27Thread the end cap into the cylinderUsing torque wrench installed 90 to the special tool, tighten the end cap
the hydraulic linesTighten the fittings on the ends of the hydraulic lines to torque of 14-18 ftIbs(19-24 Nm)16839 1271 28Position
the manifold as shownInstall the tilt cylinder pin .1281 29Rotate the unit into its normal operating positionUsing the correct
fluid, fill the oil reservoir up to the fill plugInstall and tighten the fill plugDo not torque the fill plug at this time
30Run the motor, then recheck the oil levelCycle the unit several times and check the oil level when the trim and tilt cylinders