1994 Johnson/Evinrude "ER" CV 85 thru 115 outboards Service Manual, Page 331Get this manual

1994 Johnson/Evinrude "ER" CV 85 thru 115 outboards Service Manual, Page 331

Trim Sending Unit Adjustment It might be necessary to adjust the trim sending unit to coincide with the trim gauge at full
snug, so the the sending unit screws sending 5Lower the engine all the way down against the angle adjusting rod 1341135 6Observe
theadjust theIfsending unitdoes not show trim gaugethe needle center position by pivoting it up or down with screwdriver,
until the gauge shows the needle in the center position7Raise the engine and tighten the sending unit screwsLower the engine